+ Robot
+ Box filling system
+ Conveyor
+ Granulator
Dryer, Loader & Temp. Controller
+ Other equipment
+ EOAT
+ Clean Room Robot
Get acrobat
 

Hopper Dryer (Hot Air Type)

THD-5α/THD-5Jα

Features
  • High heat efficiency.
  • No remoistening.
  • No prevention of molding machine operation.
  • Improved window for checking remaining material.
  • Dehumidifying type (J type) available.

We take care of even small things.
High performance in the compact body.

  1. An under-hopper space through which some pressurized material flows down allows pressure on the material to dissipate, drastically reducing bridge phenomenon which is often seen in small dryers. (patent pending)
  2. The separation of the hopper from the other components provides easy maintenance, material feeding, and cleaning. See the right figure.
  3. A filter dust collector is equipped for higher and more consistent performance, compared to a cyclone duct collector.
Download
Catalog

 

Catalog

| THD-5α | THD-5Jα |

Specification
Model
THD-5α/5Jα
Capacity
5kg(8.3ℓ)
Power supply
Single phase 200V(50Hz/60Hz)
Temperature control range
Ambient - 150 °C
Heater
1KW
Blower motor
Single phase 28/32W
Static air pressure(50/60Hz)
15.2/22.1mmAq
Flow rate (50/60Hz)
1.6/1.8m3
Heater control
PID
Dehumidifying method
Polymer separation membrane system
(J type only)
Required compressed air pressure
Over 0.5Mpa (J type only)
Required air consumption
110ℓ./min (J type only)
Dew point of dehumidifier
Below -40°C (at atmospheric pressure)
(J type only)
Weight
13.5kg (J type 14.5kg)
Press tons
1~15 ton

Dimension Controller right Controller left
Overall height (mm)
606
653
Overall width (mm)
310
292
Overall depth (mm)
441
338
Hopper height (mm)

390

Hopper diam. (mm)
200

*The controller is right installed in standard. Left installation is optional.
*Capacity is calculated based on a specific gravity of 0.6.
*Press tones are approximate values. To find correct values, use the below equation, material throughput an hour x drying time.

top