• Very little dust
  The cutters do not re-cut the sprues and runners in the same place, thus minimizing dust production, static electricity, and heat generation.
  
• Very few miscuts
  The spacing between the blades approximately duplicates the size of the original material pellets, so sprues and runners get granulated to roughly the same dimension.There are very few miscuts.
  
• Quiet operation
  Cutting is held to a minimum, thus the machine is very quiet.
  
• Easy cleaning
  Because there is minimal static electricity produced, any dust created doesn't adhere to interior surfaces. Moreover, two large panel doors open downward to afford greater cleaning convenience, and, ultimately, significantly shorten cleaning time and downtime. (Average cleaning time:5-7 minutes)

The hinged hopper ensures safety operation.	The hopper faces in three directions and can be clamped.	Large casters are used.
8m/m press cutter is installed as standard. 6m/m one is optionally available.	Standard suction tank

 Standard Accessory

• Cleaning awl
• Suction tank for level gauge
• Level gauge to stop feed at full

 Optional Accessory

• 6m/m press cutter
• Materials tank